Search

You are in the category: XR1200X Tools

31 products found. Go to page:

<< Previous  
1   2   3   4  
Next >>

   
Optimate Lithium charger€82,00  Add to cart 
The OptiMate Lithium 0.8A 4S charges LiFePO4 / LFP (Lithium Iron Phosphate) 4-series batteries with nominal voltage of 12.8V – 13.2V. Special features: Saves low voltage LiFePO4 batteries Specialized LiFePO4 charge cycle Maintains & protects LiFePO4 batteries Battery BMS reset. CHARGING ...
   
Socket 1/2 inch drive 12 point size 1/2 inch€9,90  Add to cart 
Socket 1/2 inch drive 12 point size 1/2 inch Tengtools Socket for all aircooled Buell and Sportster models head bolts
   
SAE thread restorer kit€90,00  Add to cart 
SAE thread restorer kit for Buell and Harley the most common used sizes, - Contains: - 7 SAE Coarse Dies, sizes: 1/4"-20, 5/16"-18, 3/8"-16, 7/16"-14, 1/2"-13, 9/16"-12, 5/8"-11 - 7 SAE Fine Dies, sizes: 1/4"-28, 5/16"-24, 3/8"-24, 7/16"-20, 1/2"-20, 9/16&q...
   
Buell front fork Oil level tool€59,00  Add to cart 
Buell front fork Oil level tool. Forall Buell and XR1200 and Sportster models For checking and adjusting the oil level on all conventional and single chamber cartridge forks Adjustable ring will measure oil levels from 0 to 300mm in 0.5cm increments Syringe has a capacity of 60ml Can be used on motorcycles equippe...
   
Ringer Fork Seal Driver, 43mm€67,00  Add to cart 
Ringer Fork Seal Driver, 43mm* * Buell XB models 2005-up ( except the 2008- X models ) and XR1200 all models Fits 43mm fork legs Innovative design makes tool easier and safer to use than old fashioned pin aligned drivers Anodized aluminum locking ring features knurled finish for secure no-slip grip and positively lo...
   
Buell Suspension tool Front and Rear€635,00  Add to cart 
Buell Suspension tool for Front Fork and and RearSuspention disassembeling.All in one Suspention tool. USed for All Buell models, all Sportster models and all XR1200 models. The best solution for the disassembling of the springs from mono or standard rear shock absorbers, or replace springs and cartridges from front f...
   
Cable luber TM€16,70  Add to cart 
Cable Luber This tool is used to inject lubricant into any mechanical cable housing. The tool clamps over your cable housing and inner cable allowing you to connect an aerosol lube can of cablelube to this luber tool. Spray until the lube runs out the other end of cable housing. For all Buell , Sportster and XR1200 ...
   
Piston ring compressor tool€142,00  Add to cart 
Jims Piston ring compressor set, supplied with 6 bands ranging from 2-7/8” to4-3/8”. Fine tooth ratcheting motion to compress bands in small increments for accurate compression(Will not break or damage rings) for all Buell and Sportster engines.
   
Hydraulic Brake Bleeder€19,00  Add to cart 
The Hydraulic brake bleeder, makes bleeding your brakes a one-person job at home. Will not bleed air from a dry system. This Brake Bleeder is a one-way check valve. This tool allows air andbrake fluid to escape, but will not allow air to re-enter the system. Note: This tool will notbleed air from a dry system, for ...
   
Receptable extractor 6 in 1 compression tong 1764€34,00  Add to cart 
6-IN-1 Star Receptacle Extractors compression tong. Easily remove an assortment of harnessstyle receptacle pins with either of these 6-in-1 tools.Designed for automobiles, we have found these to work equally well on all model Buells, XR1200 and Sportster models. No.1764 - Use on most compression tong style connectors ...
All prices are excl. VAT.