233 products found. Go to page:
|
|
|
 | | Stage 1 Buell XB9/12 2008-2010 ECM | €840,00 Add to cart | When you already have a Exhaust (we hope you buy our Torque Hammer for the Buell XB 9-12 and K&N Air filter for your Buell XB9/12 2008-2009-2010 model, and you only want too have a good running Bike, Buy this ECM with our fuel and ignition map inside. I tested this ECM with all the big exhaust manufacturers, and with al... | |
|
|
|
 | | Buell XB and Tube models, Diode start interlock | €5,65 Add to cart | Diode start interlock, For all Buell models till 2007.Sold per piece,
Used on the following models:
2000 BLAST - P3 2000
2000 CYCLONE - M2L 2000/01
2000 THUNDERBOLT - S3T 2000-01
2002 CYCLONE - M2L 2002
2002 THUNDERBOLT - S3T 2002
2003 BLAST - P3 2003
2003 FIREBOLT - XB9R 2003
FIREBOLT XB12R - (1203cc) - 2004
... | |
|
|
|
 | | Buell XB 2004-2009 exhaust valve eliminator | €49,00 Add to cart | Buell XB12 – active muffler simulator 04-09 models years
to deactivate the exhaust mufler solinoid when changed to aftermarket exhaust, or fixed the valve open
to remove the error light
easy to plug in to the cable harness next to the battery
| |
|
|
|
 | | |
|
|
 | | Buell Ecm communication device | €65,00 Add to cart | Buell ECM communication device
must need for every Bueller
to getter with a andoid device ( ECM droid ) or laptop by wireless connection,
very usefull to to check up you Buell error codes or make log files
also can be used to flash fuel mappings and change settings
| |
|
|
|
 | | Buell Intake air temp sensor wire repairkit | €36,75 Add to cart | Can be used on all fuell injected Buell models X1. S3. And all XB 9/12 2003-2010 and all 1125 R/CR 2008-2010
Intake air temp sensor wire repairkit. This is aeasy way for a repair for to the much troubledintake air temp sensor.
Only a wire end repair is needed As we deliver the connector and wire already fitted. So you... | |
|
|
|
 | | |
|
|
 | | |
|
|
 | | |
|
|
 | | M relays plus Motogadget electronic push button | €91,10 Add to cart | mo-RELAY FOR PUSH BUTTON
mo-RELAY + PUSH BUTTON FLASHER RELAY
Combines a load-independent digital flasher relay with electronic push-button controls
Four different operating modes: lane change, turn, continuous flashing and hazard
No additional push-button control unit or load resistor necessary
Constant an... | |
|
|
All prices are excl. VAT.