Articles & photos

Back

22-1-2016 1125CR big service last things to finish

27-1-2016 - What did we do Today 22-1-2016 1125CR big service last things to finish

front for oil changed and airchamber set — bij Twin Motorcycles Buell Support forever.

meeeh... brake line mod was no performed, mounting the brake line out side ( as needed ) leaves a nasty rubbing mark over time, i will turn the ugly spot the the back , and put some protective tape on the spot where the brake line sits — bijTwin Motorcycles Buell Support forever.

front wheel back in with new bearings, little grease on the axle to lube and protect from corrosion — bijTwin Motorcycles Buell Support forever.

caliper bolts back to TQ — bij Twin Motorcycles Buell Support forever.

suspention set clean the leg with a little degreaser and stick on a protective pad , on request, you can find theme here in our webshop https://www.twinmotorcycles.nl/webshop/artikel.asp?guid=YXHFSC&aid=2850 — bij Twin Motorcycles Buell Support forever.

pad rubbed down, will leave the front leg much nicer over time — bij Twin Motorcycles Buell Support forever.

brake fluids replace and bleed the hydraulic clutch— bij Twin Motorcycles Buell Support forever.

new brake fluid — bij Twin Motorcycles Buell Support forever.

and bleed the clutch as we had not done this, — bijTwin Motorcycles Buell Support forever.

on the clutch carefull pump the lever a few times helps to get the last air out the system, pump care full as releasing the lever to hard it will spray out — bij Twin Motorcycles Buell Support forever.

rear brake fluid, if your a terrible aim cover the inside so any spills are easy to clean — bij Twin Motorcycles Buell Support forever.

front brake lever pivot cleaning, need to get the mirror off for this — bij Twin Motorcycles Buell Support forever.

and take the pivot out, and clean the crusty grease— bij Twin Motorcycles Buell Support forever.

with a little tick new grease, feels like new again smile-emoticon— bij Twin Motorcycles Buell Support forever.

exhaust back on, one off the gaskets was so much destorted i need to replace it , and exhaus back on. Can be found here: https://www.twinmotorcycles.nl/webshop/artikel.asp?guid=YXHFSC&aid=1849 — bij Twin Motorcycles Buell Support forever.

 

yep is a 09 model but with a oil level looking glass , i see this more , fill engough so the engine can run , and later on check and set the level correctly — bijTwin Motorcycles Buell Support forever.

hed light bulb is out , take off the flyscreen by removing the 2 screws to the side — bij Twin Motorcycles Buell Support forever.

behind the fly screen remove the 2 top allen screws— bij Twin Motorcycles Buell Support forever.

and you can take out the headlight , to replace the bulb — bij Twin Motorcycles Buell Support forever.

check if it works — bij Twin Motorcycles Buell Support forever.

and mounth the head light back , bottom sits in the lower tripple t and screw the 2 allen screws back in— bij Twin Motorcycles Buell Support forever.

hook the flyscreen point in the headlight slot — bijTwin Motorcycles Buell Support forever.

and fasten the 2 screws to the side — bij Twin Motorcycles Buell Support forever.

reset the service counter — bij Twin Motorcycles Buell Support forever.

reset the service counter — bij Twin Motorcycles Buell Support forever.

and let here heat up , check the oil level and as we removed the wire harness mods check charging voltage ... ok — bij Twin Motorcycles Buell Support forever.

time to dress this girl up, and put the covers back on — bij Twin Motorcycles Buell Support forever.

i found the rebound settings a little out off balance, so setting the suspention , customer will love it — bij Twin Motorcycles Buell Support forever.