Articles & photos

Back

6-8-2015 XB seals O2 sensor, fuel pressure 1125

10-8-2015 - What did we do today 6-8-2015 Xb intake seals and O2 sensor,XB checking fuel pressure , 1125 key switch

Xb intake seals and O2 sensor, leaking intake seal where aleady detected, but O2 sensor is also trowing a error, but the AFV douse not change

Xb intake seals and O2 sensor, nice wrapping 

Xb intake seals and O2 sensor, ok on with it time enough to cool down a little , remove the airbox

Xb intake seals and O2 sensor, scoops off

Xb intake seals and O2 sensor, i really don't want to take this exhaust off , so creative with a tyre iron and some wood douse the trick in supporting the engine

Xb intake seals and O2 sensor, engine bolt out

Xb intake seals and O2 sensor, and engine down loosening the manifold 

Xb intake seals and O2 sensor, and the left side loose

Xb intake seals and O2 sensor, hot hot... manifold out

Xb intake seals and O2 senso, cleaned eveything up , new seals and a little grease on the idle screw 

Xb intake seals and O2 sensor, throttle bodie back on, tighten equaly

Xb intake seals and O2 sensor, engine back up again and v-brace back on

Xb intake seals and O2 sensor foot peg bracket back on

Xb intake seals and O2 sensor... eeeehh what is that bake lever pivot bolt doing on this side off the bike ?

Xb intake seals and O2 sensor, that looks better

Xb intake seals and O2 sensor, top side hooked up and connected , set tps and running check, o2 sensor douse not trow a error now , but i see voltage change , so cleared the error fro now

Xb intake seals and O2 sensor, and putting all back on

XB12ss high speed cruising problems, the engine dies , but will start up normal again, low speed cruising no problems, just checking a little things before we make a apointment ,

XB12ss, as it sound like a fuel pressure problem, measuring is knowing , airbox off to make a reading

XB12ss, fuel pressure guage on

XB12ss, ok fuel pressure is good... i really need to take more time for this, not a drop in and fix job

Xb intake seals and O2 sensor, cleared the error code, but after a half hour ride the error code came back , time to change the O2 sensor 

Xb intake seals and O2 sensor, airbox off again, engine douse not have to drop very far

Xb intake seals and O2 sensor, just enough to get my tool in there to remove the sensor

Xb intake seals and O2 sensor, old one out

Xb intake seals and O2 sensor, and fresh one in.. cleared the error codes again

1125 starting problems..

1125 starting problems, strange thing... just did one this week, and the next one in in

1125 starting problems, customer made a running repair to get the bike running

1125 starting problems,as this wire is broken on a nasty point and the bike has done 23000 km i will take a new switch , only thing is the R mode switches are not sold as spae part any more ( need to buy a complete lock ) but the CR / S model swithes are still sold , but the wires are shorter

1125 starting problems,, but that is a easy fix smile-emoticon

1125 starting problems, switch back to the key lock

1125 starting problems, removing the cover for easy mounting in the tripple t

1125 starting problems, lock back in and cover can be pushed on

1125 starting problems, route the wire back in with some slack , not to much , and not to little , and zipty to the cable harness