Articles & photos

Back

27-6-2014 Buell Xb12SCG, Xb9SX, M2.

28-6-2014 - Buell Xb12SCG big service and clean up. Buell Xb9SX 2010, Torque hammer upgrade. Buell M2, belt broke.

 Buell Xb12SCG big service and clean up.

 

Buell Xb12SCG big service and clean up, oil leaking for some time ?!! dealer did not bother..

 

Buell Xb12SCG big service and clean up, but we will fix it.

 

Buell Xb12SCG big service and clean up , fist oil drain gearbox and swingarm.

 

Buell Xb12SCG big service and clean up, engine dropped, to replace the old rocker cover seals for better black ones,

 

Buell Xb12SCG big service and clean up , the replacement Black seals are much better.

 

Buell Xb12SCG big service and clean up , and leaking intake gaskets where also taken care off.

 

Buell Xb12SCG big service and clean up , cleaning the throttle body and rocker cover.

 

Buell Xb9SX 2010, Torque hammer upgrade, removal off the rusty can.

 

Buell Xb9SX 2010, Torque hammer upgrade,after ecm upgrade, test ride..  i always love this part.

 

Buell M2, belt broke.

 

Buell M2, belt broke, first loosen the lower tyrod.

 

Buell M2, belt broke , bring out the big tools to loosen the isolator bolt.

 

Buell M2, belt broke , handy tool to compress the left isolator , to give room for the right isolator to be removed.

 

Buell M2, belt broke , loosen the rear fender.

 

Buell M2, belt broke , and remove the tool, wiggle the belt in , and place back the spreader tool.

 

Buell M2, belt broke , position back the isolator and check if it seats in the little dowel pin.

 

Buell M2, belt broke , remove the tool , and when you have supported the bike ( engine ) good, the hole for the isolator bolt will line out... TQ down.

 

Buell M2, belt broke , set tension on the belt and place back bolts and cover.. Some m2 or S1 are hard, but this one was done in 30 minutes.

 

Buell Xb12SCG big service and clean up , service almost done, customer wanted a nice handle bar.

 

Buell Xb12SCG big service and clean up , with new handle bars we always drill the switch locating pins in the handle bar so they can not turn.

 

Buell Xb12SCG big service and clean up , as the handle bar is a little wider than stock.. we needed more throttle cable.. as they did run out side the guide.

 

Buell Xb12SCG big service and clean up , we did put theme back in the cable guide, and gained a few cm lenght, just what we needed.

 

ULY day , 

i counted 7 at one time in our shop.