Articles & photos

Back

18-6-2014 Buell 1125R, Xb12STT, 1125Cr.

19-6-2014 - Buell 1125R 2008, charging problems. Buell Xb12STT 2007 top end rebuild. Buell 1125Cr 2009, stator and rotor upgrade.

buell 1125R 2008, charging problems, measuring resistance to ground off stator, looks good.

 

buell 1125R 2008, charging problems,diode block test.

 

buell 1125R 2008, charging problems,diode block test reversed polarity.

 

buell 1125R 2008, charging problems, voltage on battery while running... way to low.

 

buell 1125R 2008, charging problems, quick test with new regulator.

 

buell 1125R 2008, charging problems, Ac out put from stator at idle , looks good to me.

 

buell 1125R 2008, charging problems, replacing the regulator, hard to reach.

 

buell 1125R 2008, charging problems,with the center nut from the undertray loose you can just wiggle it out and in.

 

buell 1125R 2008, charging problems,, fasten screw after somebody forget's it (-:

 

buell 1125R 2008, charging problems, will also put the battery strap on, as the last HD dealer did not bother to do.

 

buell 1125R 2008, charging problems, a rare find in Europe , a California model ( with carbon canister )

 

buell 1125R 2008, charging problems,battery voltage not running.

 

buell 1125R 2008, charging problems,battery voltage running idle , good to go.

 

Xb12STT 2007 top end rebuild, putting back the pieces.

 

Xb12STT 2007 top end rebuild, top T-rod support back on.

 

Xb12STT 2007 top end rebuild, headers back on.

 

Xb12STT 2007 top end rebuild, front engine mount.

 

Xb12STT 2007 top end rebuild, new coated primary cover Bling.

 

Xb12STT 2007 top end rebuild, chain tensioner back on , i did use a new nut as the seal on the old one was gone.

 

Xb12STT 2007 top end rebuild, shifter axle seal in and cover on.

 

Xb12STT 2007 top end rebuild, lying up the clutch cable a carefuly screw it back in.

 

Xb12STT 2007 top end rebuild, oil in, shifter mechanism back on.

 

Xb12STT 2007 top end rebuild, not the easies exhaust to mount  and to get rattle free.

 

Xb12STT 2007 top end rebuild, setting primary chain tension.

 

Buell 1125Cr 2009, stator and rotor upgrade, customer had already removed allot but asked us to change the rotor.

 

Buell 1125Cr 2009, stator and rotor upgrade,rotor off.

 

Buell 1125Cr 2009, stator and rotor upgrade,cleaning threats on the starter clutch bolts.

 

Buell 1125Cr 2009, stator and rotor upgrade, and rotor back on with new nut and 272 loctite.

 

Buell 1125Cr 2009, stator and rotor upgrade,and put the stator in for him.