Articles & photos

Back

15-5-2014 Buell Xb9SX, m2, Xb12STT, Xb12SX.

16-5-2014 - Buell Xb9SX, 2006, small service and inspection. Buell Xb9SX, 2005 big service. Buell m2 problem 1 gear, take 2. Buell Xb12STT 2007, valve train noise / hard tikking. Buell Xb12SX 2010, back in black.

Mail call, a other crank send in by customer to repair the big end bearings with our improved big end pin and bearing.

 

Buell Xb9SX, 2006, small service and inspection.

 

Buell Xb9SX, 2006, small service and inspection , rear brake light was not working, we put a other switch on.

 

Buell Xb9SX, 2006, small service and inspection, side stand pivot bolt, old model.. needed to be tightened.

 

Buell Xb9SX, 2006, small service and inspection , front wheel bearing check, as we needed to replace the rear wheel bearings, these are good.

 

Buell Xb9SX, 2006, small service and inspection, the old brake pads would not last untill the next service, better replace theme now.

 

Buell Xb9SX, 2006, small service and inspection, rubbing wires, better put theme in a safe position, this is the dyno rpm pick up, ignition wire, so when short to ground will blow up the fuses / or coil.

 

Buell Xb9SX, 2006, small service and inspection , that is one way to mount a wrong battery, but check the poles on tightness.

 

Buell Xb9SX, 2006, small service and inspection , warming up and oil level check, ready for the road.

 

Buell Xb9SX, 2005 big service.

 

Buell Xb9SX, 2005 big service, bussy in the shop , took to little picutes, bike almost done :-0

 

Buell m2 problem 1 gear, take 2, the bike has some times the feeling of no drive, and comes in with a shock, only in 1e gear, and not always...

 

Buell m2 problem 1 gear, take 2, primary off again, check the clutch.

 

Buell m2 problem 1 gear, take 2, basket bearing has allot off play and the hub can move about 2 mm, but sticks sometimes.. could this be it ?

 

Buell m2 problem 1 gear, take 2, pressed out eh hub, and marks from rubbing , new bearing on and the hub was tight again, mount back and try again.

 

Buell Xb12STT 2007, valve train noise / hard tikking.

 

Buell Xb12STT 2007, valve train noise / hard tikking.

 

Buell Xb12STT 2007, valve train noise / hard tikking , stripping the top side.

 

Buell Xb12STT 2007, valve train noise / hard tikking , removing the timing cover , as this one will be coated black.

 

Buell Xb12STT 2007, valve train noise / hard tikking , rocker boxes off to relieve the spring tension and the gear cover and cams can come out.

 

Buell Xb12STT 2007, valve train noise / hard tikking , heads, cylinders and pushrod covers off to check the lifters.

 

Buell Xb12STT 2007, valve train noise / hard tikking , pistons and cylinders look good.

 

Buell Xb12SX 2010, back in black, last things back from the coater.

 

Buell Xb12SX 2010, back in black, looks good  .