Articles & photos
| Back |
9-5-2014 Buell X1, M2, Xb12X.
10-5-2014 - Buell X1 running problems. Buell M2 take 12. Buell Xb12X, ecm mapping and test ride.
Buell X1, running problems, bad running, AFV at 140 , tps only 2,6 deg and still idle 1100 rpm.. where to start.. intake seals very heavy suspect.
Buell X1, running problems, little piched wires at the steering colom.
Buell X1, running problems, xb where not the first with a cooling fan, was a after market kit available for the X1 models.
Buell X1, running problems, tank cover off, and outer airbox cover, always a mess in here.
Buell X1, running problems, cooling fan position.
Buell X1, running problems, tank off to get to the intake manifold.
Buell X1, running problems, breather hoses are worn in, will replace theme.
Buell X1, running problems, rear one the same.
Buell X1, running problems, other pinched wire.
Buell X1, running problems, seals marking off leaking.
Buell X1, running problems, you see here the point where it did leak.
Buell X1, running problems, cleaning up and rebuilding..still running not really nice.. mnnn.. first cool down.
Buell M2 take 12... bike will only run on full choke, carb was already cleaned...
Buell M2 take 12, carb take apart again... checking for jet sizing.
Buell M2 take 12, also have a look at the needle.
Buell M2 take 12, just wondering why they put the rings on top off the clip , but looks good, put in a 45 slow as with open pipe and open airfilter the 42 is a little small.
Buell M2 take 12, cover back on, use the spacer on the cable holder point.
Buell M2 take 12, float lever double check.. ok.
Buell M2 take 12, carb back on.
Buell M2 take 12... yeah.. running idle and is responding on idle adjustments finaly.
Buell M2 take 12, fuse box was heavy corroded, customer cleaned it all ready some time ago, but was still looking bad, plastic bag and contact cleaner for a while will sort this.
Buell M2 take 12, looking better already.
Xb12X, ecm mapping and test ride always nice to start the day, did need to set the suspention, bike was steering badly, all the settings where off.
