Articles & photos

Back

14-3-2014 Buell xb12S, XR1200, Xb12S 08, 1125CR.

20-3-2015 - Buell xb12S, making front exhaust strap bullit proof. XR1200, clutch plate replacement. Xb12S 2008, finishing the job. Buell 112CR, fuel mapping. Buell Xb12S, stopped during riding.

 Buell xb12S, Grace, making front exhaust strap bullit proof, customer broke 3 orginal strap, time to make it beter, cut and welded a new stainless strap bracket.

 

Buell xb12S, Grace, making front exhaust strap , and fitted a bullit proof heavy duty strap  i think it will hold  now.

 

 

XR1200 clutch plate replacement, customer bought a new clutch pack from us, and wanted to replace theme him self, but after realising some tools where needed , he asked if we could do this for him, off course , with the right tools easy job.

 

XR1200 clutch plate replacement,customer soaked the plates already.

 

XR1200 clutch plate replacement,mounted back in the pul plate to attach the tool.

 

XR1200 clutch plate replacement, i really like to replace theme in the basket , and we have many lying around.

 

XR1200 clutch plate replacement,clutch spring compression tool on.

 

XR1200 clutch plate replacement,compres the tool and take out the C-clip and the C-clip seat ring.

 

XR1200 clutch plate replacement,, releasing the spring compression tool and remove the spring, Always check under the spring for debris and dirt trapped, this can cause the clutch to not come free.

 

XR1200 clutch plate replacement, old plates out, new ones in , by doing this in the basket you know for sure the plates will line up.

 

XR1200 clutch plate replacement, spring back on with the compression tool, easy peasy , ready to be mounted by customer.

 

Xb12S 2008, finishing the job, putting back the body parts.

 

Xb12S 2008, finishing the job, putting back the body parts, air filter back on.

 

Xb12S 2008, finishing the job, putting back the body parts, pully cover back on.

 

 

Xb12S 2008, finishing the job, putting back the body parts, she still is a nice looking bike.

 

Buell 112CR, after test ride with fuel mapping, i felt the suspention was not really set up good, a little to hard rebound, was feeling a little strange in conrners , talked to customer, and set it better.

 

Buell Xb12S, stopped during riding, checking for errors , seams no spark ?

 

Buell Xb12S, stopped during riding, checking plugs, there where HD plugs in with wrong heat grade, place some good ones.

 

Buell Xb12S, stopped during riding, rear plug was only half in  , after other plugs, the bike still would not run... and started to make very strange noise.. i stopped, right there, as the customer just bought the bike, but sounds very bad