Articles & photos

Back

8-2-2018, 1125CR oil out the exhaust, EBR1190RX

3-5-2018 - What did we do today: 8-2-2018 1125CR oil out the exhaust, EBR1190RX 1e service

1125CT trouble shooting, heavy smell of oil ? behind the bike .. — bij Twin Motorcycles Buell Support forever.

battery is also flat.. so first checking the charging — bij Twin Motorcycles Buell Support forever.

rear plug check is easy enough.. coil out — bij Twin Motorcycles Buell Support forever.

and sparkplug out.. running rich / short rides.. need to change the plugs anyway and check the valve play — bij Twin Motorcycles Buell Support forever.

running... 2 side exhaust.. belt guard is very in the way — bij Twin Motorcycles Buell Support forever.

and cannot remove it.. need to screw the backing plate out — bij Twin Motorcycles Buell Support forever.

backing plate loose .. — bij Twin Motorcycles Buell Support forever.

idle AC check.. 23 volts , no problem charging — bij Twin Motorcycles Buell Support forever.

error codes also little indications — bij Twin Motorcycles Buell Support forever.

removing the airbox cover.. 1 brass insert pulled out— bij Twin Motorcycles Buell Support forever.

 

home made steering damper mounts .. nice one.. expencife damper — bij Twin Motorcycles Buell Support forever.

 

 

airbox removed.. case breather no indication on much oil spuwwing .. — bij Twin Motorcycles Buell Support forever.

 

 

the aic is still on.. wil remove this — bij Twin Motorcycles Buell Support forever. Also Twin Motorcycles intake stack mounted 

no clear indiction on oil cunsumption,, oil level check.. ok nothing there needed 3/4 liter to get up to level — bij Twin Motorcycles Buell Support forever.

ther has been some oil leaking .. i suspect the mufflers are coated in oil and burning off ? next to a rich mixture blowing black out the exhaust full throttle ? — bij Twin Motorcycles Buell Support forever.

intake valves look clean — bij Twin Motorcycles Buell Support forever.

both cylinders ok — bij Twin Motorcycles Buell Support forever.

oil to level.. lets try again — bij Twin Motorcycles Buell Support forever.

i see the exhaut smoking heavy when on the throttle— bij Twin Motorcycles Buell Support forever.

need to take these of engine rotation , i wil look and clean — bij Twin Motorcycles Buell Support forever.

removing the front springs — bij Twin Motorcycles Buell Support forever.

and the exhaust — bij Twin Motorcycles Buell Support forever.

greasy — bij Twin Motorcycles Buell Support forever.

and greasy up here — bij Twin Motorcycles Buell Support forever.

yep.. these are low to the ground — bij Twin Motorcycles Buell Support forever.

inside pipe no indication on worn valve seals — bij Twin Motorcycles Buell Support forever.

but the outside looks wet from oil — bij Twin Motorcycles Buell Support forever.

prepping for engine rotation — bij Twin Motorcycles Buell Support forever.

i wil put some new bearings in — bij Twin Motorcycles Buell Support forever.

mnnn need to mount the head light again.. the lower palls are not in the triple t — bij Twin Motorcycles Buell Support forever.

could be there is littel room with the HID light units on — bij Twin Motorcycles Buell Support forever.

marking the x pipe so easy mounting — bij Twin Motorcycles Buell Support forever.

front header off to look inside the exhaust valves — bij Twin Motorcycles Buell Support forever.

black.. but not wet from oil — bij Twin Motorcycles Buell Support forever.

plug out the cover to turn over the engine — bij Twin Motorcycles Buell Support forever.

inlet out — bij Twin Motorcycles Buell Support forever.

.and giving the horn an O2 wire some room — bij Twin Motorcycles Buell Support forever.

removing the front plug — bij Twin Motorcycles Buell Support forever.

a little better than the rear one — bij Twin Motorcycles Buell Support forever.

cover of — bij Twin Motorcycles Buell Support forever.

and turning the engine so i can check the valve play— bij Twin Motorcycles Buell Support forever.

intakes are good. exhaust valve are tight..at a minimum — bij Twin Motorcycles Buell Support forever.

i will adjust these removing the finger spacer — bij Twin Motorcycles Buell Support forever.

and with a little magnet on a stick. you can lift out the shims — bij Twin Motorcycles Buell Support forever.

some writing down what how en where helps — bij Twin Motorcycles Buell Support forever.

close enough .. — bij Twin Motorcycles Buell Support forever.

shims in, fingers slided on the valve, turn the engine over a turn. and check what you have been doing.. these are good — bij Twin Motorcycles Buell Support forever.

new spark plug in.. check and set the electrode gap.. very often these are to close — bij Twin Motorcycles Buell Support forever.

coil back on.. make sure the connector locks .. — bij Twin Motorcycles Buell Support forever.

so moving to the rear.. need to get the clutter out the way first — bij Twin Motorcycles Buell Support forever.

aic cable of — bij Twin Motorcycles Buell Support forever.

and loosening the rear cables , so i can pull it aside to make room for the valve cover — bij Twin Motorcycles Buell Support forever.

nice... first oil change on a 1190... excelent colour — bij Twin Motorcycles Buell Support forever.

fresh out the box — bij Twin Motorcycles Buell Support forever.

lower fairing piece off — bij Twin Motorcycles Buell Support forever.

and draining the right side — bij Twin Motorcycles Buell Support forever.

and left side — bij Twin Motorcycles Buell Support forever.

to be expected first oil.. some debris — bij Twin Motorcycles Buell Support forever.

oil filter cover of — bij Twin Motorcycles Buell Support forever.

cover of to check . nice chain guard — bij Twin Motorcycles Buell Support forever.

chain tension was way to loose.. swingarm protection is wearing out hard.. — bij Twin Motorcycles Buell Support forever.

oil filter out.. more debris .. as the oil also runs the gearbox.. normal the first few km — bij Twin Motorcycles Buell Support forever.

new oil filter in — bij Twin Motorcycles Buell Support forever.

going to remove the exhaust to inspect the oil screen ,, chain idler out to get to the exhaust bolr — bij Twin Motorcycles Buell Support forever.

.

left foot peg bracket loose , and exhaust bolt loose— bij Twin Motorcycles Buell Support forever.

and 2 front straps the exhaust dropped out — bij Twin Motorcycles Buell Support forever.

loosen the cover — bij Twin Motorcycles Buell Support forever.

reson of this exersition .. clean this out — bij Twin Motorcycles Buell Support forever.

take some pliers and pull the screen out — bij Twin Motorcycles Buell Support forever.

as there will be some debris on to — bij Twin Motorcycles Buell Support forever.

cleaning the cover still made in Austria.. but the rotax sign is grinded off ;-) — bij Twin Motorcycles Buell Support forever.

 

screen back in place — bij Twin Motorcycles Buell Support forever.

 

 

and the lumpy piece off metal back on — bij Twin Motorcycles Buell Support forever.

 

 

screws back in — bij Twin Motorcycles Buell Support forever.

 

 

i loose the right side peg.. easier to slide the exhaust inbetween — bij Twin Motorcycles Buell Support forever.

 

 

idler wheel back on — bij Twin Motorcycles Buell Support forever.

 

 

need to get a good hook stand.. for now removing the traction control sensor — bij Twin Motorcycles Buell Support forever.

 

 

and the chain guard so i can use out paddock stand— bij Twin Motorcycles Buell Support forever.

 

 

chain is way to loose for a 1190... — bij Twin Motorcycles Buell Support forever.

 

 

size 36 socket to loosen the nut — bij Twin Motorcycles Buell Support forever.

 

and setting the tension.. — bij Twin Motorcycles Buell Support forever.

check the alignment .. the dots are a very good help— bij Twin Motorcycles Buell Support forever.

give the wheel a spin around , if to tight you will notice — bij Twin Motorcycles Buell Support forever.

pully cover has a frame slot to position in the frame— bij Twin Motorcycles Buell Support forever.

and undertray back on — bij Twin Motorcycles Buell Support forever.

pesky front screws and nuts — bij Twin Motorcycles Buell Support forever.

checkign the oil level.. on the side stand ... it is getting better.. still a pain in the ass — bij Twin Motorcycles Buell Support forever.

and setting the suspention to weight — bij Twin Motorcycles Buell Support forever.

as this was not done... preload front — bij Twin Motorcycles Buell Support forever.

and dampeing front — bij Twin Motorcycles Buell Support forever.