Articles & photos
Back |
25-3-2017 1125 Cr Bas sensor, front XB error
14-4-2017 - 25-3-2017 Buell 1125CR Bas sensor, Buell 1125CR front disk and Exhaust, Buell XB9SX error light
early morning... error light check .. indication BAS sensor — bij Twin Motorcycles Buell Support forever.
checking the codes... the Can sensor is common.. but the Bas sensor douse not happen allot — bij Twin Motorcycles Buell Support forever.
left scoop removed.. wireing look ok.. i will replace the sensor — bij Twin Motorcycles Buell Support forever.
very nice stuff on this 1125.. :-) — bij Twin Motorcycles Buell Support forever.
next 1125... ,in for front disk and exhaust swap — bij Twin Motorcycles Buell Support forever.
first the front brake — bij Twin Motorcycles Buell Support forever.
still on the ground loosing the caliper bolts — bij Twin Motorcycles Buell Support forever.
and loosen the pins — bij Twin Motorcycles Buell Support forever.
slider out — bij Twin Motorcycles Buell Support forever.
pinch bolts loose and axle out — bij Twin Motorcycles Buell Support forever.
line up the caliper with the slots in the wheel and slide the caliper off — bij Twin Motorcycles Buell Support forever.
pressing back the pistons best done with the pads in ( easier ) — bij Twin Motorcycles Buell Support forever.
wheel out.. off course we checked the bearings... and old warped disk off — bij Twin Motorcycles Buell Support forever.
new Twin Motorcycles disk on.. bolt to 35 Nm — bij Twin Motorcycles Buell Support forever.
new pads in — bij Twin Motorcycles Buell Support forever.
wheel back in and tighten the axle — bij Twin Motorcycles Buell Support forever.
pump the brake to pressure ... you will not be the first who needs to brake and after brake repair.. grabs the lever to the handle bar and not have brake pressure — bij Twin Motorcycles Buell Support forever.
now bump the suspention a few times to set the front forks on the axle — bij Twin Motorcycles Buell Support forever.
note the axle sits below the outer leg.. — bij Twin Motorcycles Buell Support forever.
if you would tighen the crash sliders to hard you will move the fork over the axle .. so tight as in hand tight will do — bij Twin Motorcycles Buell Support forever.
the old exhaust has blown off already ones... time to replace this — bij Twin Motorcycles Buell Support forever.
mnnn happy warm feelings when the 6 mm allen slips in the bolt — bij Twin Motorcycles Buell Support forever.
old inex socket and hammer in it in .. did the trick— bij Twin Motorcycles Buell Support forever.
yep.. had a few that had blown off — bij Twin Motorcycles Buell Support forever.
the mounting bracket was in between the foot rest and the enigne , the bolts used for mounting are now to long.. — bij Twin Motorcycles Buell Support forever.
shorter bolts back in. and foot rest on place — bij Twin Motorcycles Buell Support forever.
termi.. springs on the exhaust , these are a pain to mount when on the bike — bij Twin Motorcycles Buell Support forever.
take a hand and sqeuse the pipes to mount the exhaust collector — bij Twin Motorcycles Buell Support forever.
the rear mount bolt in place — bij Twin Motorcycles Buell Support forever.
and the front mounting bolt on place — bij Twin Motorcycles Buell Support forever.
customer bought the used exhaust with tuned ecm .. nice — bij Twin Motorcycles Buell Support forever.
so out with the old and in with the tuned ecm — bij Twin Motorcycles Buell Support forever.
is a 2009 model, but a 2010 engine with oil looking glas is in ... good upgrade — bij Twin Motorcycles Buell Support forever.
replacing the mirrors — bij Twin Motorcycles Buell Support forever.
for some better looking, and still have indicator function — bij Twin Motorcycles Buell Support forever.
binding cables back — bij Twin Motorcycles Buell Support forever.
mnnn... i'm alergic to sticking throttles... and 9 out off 10 it is the bar end weight causing this.. — bij Twin Motorcycles Buell Support forever.
connections made for the indicators.. as these are LED the polarity is important — bij Twin Motorcycles Buell Support forever.
Xb9Sx in with trouble light — bij Twin Motorcycles Buell Support forever.
mnn first tought was fan.. it is messy from oil leaking rear rocker cover .. but fuse is good and fan still works.. — bij Twin Motorcycles Buell Support forever.
still this is something that needs to be fixed, as this leaking will detroy the cooling fan — bij Twin Motorcycles Buell Support forever.
battery cable loose — bij Twin Motorcycles Buell Support forever.
looking at the burn spots , has been sparking... — bij Twin Motorcycles Buell Support forever.
explains the error codes — bij Twin Motorcycles Buell Support forever.