Articles & photos

Back

15-3-2017 1125 Service finish, ULY black parts

31-3-2017 - What did we do Today: 15-3-2017 Buell 1125 Service finish, Buell Xb12X making things black

airbox base plate back on the 1125. pull the throttle to check the cables / rods are not binding — bij Twin Motorcycles Buell Support forever.

fuel pressure sensor / fuel line back on the holder— bij Twin Motorcycles Buell Support forever.

Map sensor back on, needs to point down — bij Twin Motorcycles Buell Support forever.

airfilter and cover back on. some stainless bolts for the steering damper bracket — bij Twin Motorcycles Buell Support forever.

pushed down the suspention a few times and tighten the axle pinch bolts — bij Twin Motorcycles Buell Support forever.

body work back on, including the fairing brackets 

TH exhaust back on — bij Twin Motorcycles Buell Support forever.

fresh brake fluid in the front — bij Twin Motorcycles Buell Support forever.

and fresh brake fluid for the hydro clutch , this will alway look black over time — bij Twin Motorcycles Buell Support forever.

carefull filling and pomp the lever a few times — bij Twin Motorcycles Buell Support forever.

and rear brake fluid replaced — bij Twin Motorcycles Buell Support forever.

making the quick shifter shorter as we adjusted the shift lever up a notch — bij Twin Motorcycles Buell Support forever.

getting ready.. only the fairing screw left :-) — bij Twin Motorcycles Buell Support forever.

contact... and heating up the bike for oil level check— bij Twin Motorcycles Buell Support forever.

customer wanted the quick shifter to work for 2e gear also.. so adjusting the setting in the stock ecm— bij Twin Motorcycles Buell Support forever.

2 minutes wait to check the level.. — bij Twin Motorcycles Buell Support forever.

some protection to slide the fairing back on — bij Twin Motorcycles Buell Support forever.

and get ride off my greasy finger prints on the bike :-) — bij Twin Motorcycles Buell Support forever.

and service counter reset... contact on, hold mode and toggle to get to the menu, — bij Twin Motorcycles Buell Support forever.

press mode to get to service counter , and press toggle to reset — bij Twin Motorcycles Buell Support forever.

and service counter resets at 10000 km ... ready to test ride :-) — bij Twin Motorcycles Buell Support forever.

Uly... blacing out wheels, seat frame and cockpit — bij Twin Motorcycles Buell Support forever.

wheels back from the coater — bij Twin Motorcycles Buell Support forever.

prepping the wheels , new bearings in, the blasted surface , a light coat off neversees , as the disk / pully will corrode stuck on the hub — bij Twin Motorcycles Buell Support forever.

rear disk back on, bolts to 35 Nm — bij Twin Motorcycles Buell Support forever.

tyre back on.. and wheel back in — bij Twin Motorcycles Buell Support forever.

cleaning the ground points on the seat brackets — bij Twin Motorcycles Buell Support forever.

and bought spars back on — bij Twin Motorcycles Buell Support forever.

the 2 front undertray screws in — bij Twin Motorcycles Buell Support forever.

battery tray back in — bij Twin Motorcycles Buell Support forever.

and tail section mounted — bij Twin Motorcycles Buell Support forever.

eeehhh no... made a solder joint for this cable — bijTwin Motorcycles Buell Support forever.

cockpit back on — bij Twin Motorcycles Buell Support forever.

mnnn need some repair — bij Twin Motorcycles Buell Support forever.

and headlight wires where cut — bij Twin Motorcycles Buell Support forever.

i made the wires longer and fitted a original connector back on — bij Twin Motorcycles Buell Support forever.

cockpit side plates back in loosly with 1 bolt — bij Twin Motorcycles Buell Support forever.

ignition lock back on , security bolts , do not tighten the bolts yet, first mount the top part off the cockpit— bij Twin Motorcycles Buell Support forever.

power plug back in the top piece — bij Twin Motorcycles Buell Support forever.

top piece mounted, and tighten the side plates and ignition switch — bij Twin Motorcycles Buell Support forever.

dash back in — bij Twin Motorcycles Buell Support forever.

head light bracket back on, and flyscreen on — bij Twin Motorcycles Buell Support forever.

prepping the front wheel, new bearings — bij Twin Motorcycles Buell Support forever.

disk and tyre mounted — bij Twin Motorcycles Buell Support forever.

old spare out — bij Twin Motorcycles Buell Support forever.

and Black wheel back in — bij Twin Motorcycles Buell Support forever.

front fender on — bij Twin Motorcycles Buell Support forever.

and ready to go.. looks good with the black parts — bij Twin Motorcycles Buell Support forever.