Articles & photos
Back |
4-3-2017 custom wire harness, XR1200 longer gears
16-3-2017 - What did we do 4-3-2017 Buell XB12 custom wire harness, XR1200 longer gears ( mounting cruise kit )
and on we go.. ignition relais needs a feed — bij Twin Motorcycles Buell Support forever.
i love these solder connectors , with heat shrink — bij Twin Motorcycles Buell Support forever.
perfect connection isolated and watter tight — bij Twin Motorcycles Buell Support forever.
on with the speedo — bij Twin Motorcycles Buell Support forever.
took out the shematics — bij Twin Motorcycles Buell Support forever.
and one connector done — bij Twin Motorcycles Buell Support forever.
mnnn lets have a look suspisieus allot off tape — bij Twin Motorcycles Buell Support forever.
ok wire end to wire end soldered... — bij Twin Motorcycles Buell Support forever.
the sensor plug is very empty.. i will put some more in, as the speedo can handle it — bij Twin Motorcycles Buell Support forever.
connected.. starting to look like it — bij Twin Motorcycles Buell Support forever.
XR1200 lowering the rpm while cruising.. very neath sollution is our cruise kit , speedo reading stays accurate , and drops the rpm with about 500 rpm — bij Twin Motorcycles Buell Support forever.
draining the gearbox oil — bij Twin Motorcycles Buell Support forever.
clutch cable adjuster turned in — bij Twin Motorcycles Buell Support forever.
shift lever off — bij Twin Motorcycles Buell Support forever.
clutch mechanime out — bij Twin Motorcycles Buell Support forever.
and chain tensiner loose — bij Twin Motorcycles Buell Support forever.
bolts out — bij Twin Motorcycles Buell Support forever.
and laying it to the side — bij Twin Motorcycles Buell Support forever.
pulling plate for the clutch out, to get to the nuts on the mainshaft — bij Twin Motorcycles Buell Support forever.
these can be a pain to remove there are very tight.. working on a hot engine has it advantage — bij Twin Motorcycles Buell Support forever.
engine sprocket off with chain — bij Twin Motorcycles Buell Support forever.
old one out,, bigger new one in.. — bij Twin Motorcycles Buell Support forever. The kit can be found here: https://www.twinmotorcycles.nl/webshop/artikel.asp?guid=YXHFSC&aid=3119&cid=0&s=cruise&a=&aname=Twin_Motorcycles_XR1200_cruise_gearing_kit_
there is also a new chain in the kit — bij Twin Motorcycles Buell Support forever. The kit can be found here: https://www.twinmotorcycles.nl/webshop/artikel.asp?guid=YXHFSC&aid=3119&cid=0&s=cruise&a=&aname=Twin_Motorcycles_XR1200_cruise_gearing_kit_
and a new bolt.. advice to replace this one — bij Twin Motorcycles Buell Support forever.
clutch basket back on and mainshaft nut in . left turning ! — bij Twin Motorcycles Buell Support forever.
pulling plate in, make sure the c-clip seats properly— bij Twin Motorcycles Buell Support forever.
cover back on with the new gasket out the kit , tq the cover 14 nm , start in the middle and spiral out— bij Twin Motorcycles Buell Support forever.
gearbox oil in and clutch mechnisme in and adjust lightly botteming and 1/4 turn loose — bij Twin Motorcycles Buell Support forever.
shifter back on — bij Twin Motorcycles Buell Support forever.
lift the rear wheel off the ground , gearbox in 5e and bump the rearwheel to turn the engine over. to check the primary chain — bij Twin Motorcycles Buell Support forever.
adjusted the chain on the tightes spot ( check on 3 point ) — bij Twin Motorcycles Buell Support forever.
and adjust the outer clutch cable.. . and your ready to go — bij Twin Motorcycles Buell Support forever.
The kit can be found here: https://www.twinmotorcycles.nl/webshop/artikel.asp?guid=YXHFSC&aid=3119&cid=0&s=cruise&a=&aname=Twin_Motorcycles_XR1200_cruise_gearing_kit_